Jack Plate, Manual, 10" Setback

Made of 6061 T6 extruded aluminum alloy and fastened with stainless steel fasteners.  It utilizes an all thread stainless steel screw centrally located for uniform lift and positive alignment.  The motor bracket moves up and down on the transom bracket by use of rollers matched from aluminum-bronze alloy (same as hydraulic CMC Power-Lift).  There is 5" of verticle adjustment, with a choice of 5-1/2" or 10" set back from transom.  Designed to fit any standard motor up thru V-6, 300HP without drilling holes or making modifications.  The Power-Lift provides the added convenience of adjusting from the top or the bottom.

CMC / T-H Part #: 61012